This document provides the necessary configuration required to gain management access over SSH or HTTPS externally. In order to gain management access directly from an external network, you must configure management access via HTTPS or SSH. However, on FTD devices that run software version 6.1.0, the CLI is converged, and entire ASA commands are configured on the CLISH. On FTD devices that run software version 6.0.1, the ASA diagnostic CLI is accessed as you enter the system support diagnostic-cli. With the onset of Firepower Threat Defense (FTD), the entire ASA related configuration is done on GUI. If your network is live, ensure that you understand the potential impact of any command. All of the devices used in this document started with a cleared (default) configuration. The information in this document was created from the devices in a specific lab environment. Firepower Management Center (FMC) version 6.0.1 and higher.ASA Firepower Threat Defense Image for ASA (5515-X, ASA 5525-X, ASA 5545-X, ASA 5555-X, ASA 5585-X), which runs on the software version 6.0.1 and higher.Adaptive Security Appliance (ASA) Firepower Threat Defense Image for ASA (5506X/5506H-X/5506W-X, ASA 5508-X, ASA 5516-X ), which runs on the software version 6.0.1 and higher.The information in this document is based on these software and hardware versions: Knowledge of Management Access on ASA via HTTPS and SSH (Secure Shell). Basic Knowledge of ASA (Adaptive Security Appliance).Prerequisites RequirementsĬisco recommends that you have knowledge of these topics: This document describes the configuration of management access to a Firepower Threat Defense (FTD) (HTTPS and SSH) via Firesight Management Center (FMC).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |